Knit cap with cable pattern - a guide
Instructions for a cap with cable pattern
Material: 100 g Fb 889 "Lima" (84% baby alpaca, 8% merino, 8% nylon, LL 100 m / 50 g) by Rowan, a short circular needle No. 5 + 6, a needles game No. 6
Note: It is possible that the given wool can not be bought anymore. In this case, you are looking for a similar quality. Please note the specified run length and do a stitch test!
Federal pattern (BM): With needle no. 5. 1 sts left, 1 st crossed right (insert in the rear stifle) alternately.
Cable pattern (ZM) repeat over 6 M: With needle no. 6.
1st round: 1 sts left, 1 sts crossed right, 1 sts left, draw 3rd sts on left needle over both sts in front, 1 sts on right, 1 sts, 1 sts on right ,
2nd to 4th round: 1 sts left, 1 sts crossed right, 1 sts left, 3 sts right. Always pick up the 1st to 4th round and the repeat in the width.
Knitting tension: Knitted in the ZM yields 14 sts x 20 r = 10 x 10 cm.
Manual: Cast on 72 sts, close to the round and knit 3 cm in the BM, continue to knit in the ZM. 22 cm from BM omit the envelopes = 60 sts, continue in the following pattern: * 1 st on the left, 1 st on the right, 1 st on the left, 2 st on the right, ab * always repeat. Work 24 cm from BM 1 round in the following pattern: * 1 st on left, 1 st on right, 1 st on left, 2 sts on left, knit on right, off * always repeat = 48 sts. Continue BM with double pointed needles knit (= 12 sts. per needle), while doing so and in each round knit the first and last two sts each needle until all sts have been removed.
