Make a pulling toy yourself: A bottle on wheels

Make pulling toys yourself - that's what you need:

empty bottle, here Penaten baby bath cord approx. 1m, e.g. by Krima and Isa big pointed needle or canned biscuit 2 shashlik skewers 4 giant beads, approx. 3.5 cm diameter and 6 small beads Masking tape or colorful sticky scissors craft glue small piece of emery paper

Here again the instructions for the drawing car at a glance:

Rinse the bottle well and prick four holes at the bottom, preferably parallel to each other, for the wheels (approx. 2.5 cm from the bottom edge of the bottle upwards).

Pierce a shish kebab, thread a large bead on both sides and fix with a small bead, by gluing, at both ends and allow to dry. Now cut off the protruding ends of the shish kebab and sand smooth.

The back of the bottle is now cut to size, a cord pulled through the opening in the neck of the bottle and the bottle cap cut off.

So that the cord does not slip through the opening, it is best to knot it with a small pearl on the inside. The other end, to pull, also fix with a pearl. After remaining, the finished car can now be decorated.

Duration: approx. 30-40 min